Download >>> https://byltly.com/283gdu
Have you recently downloaded GTA 4? If so, did you happen to find yourself in an unplayable state because of the game’s DFA.dll file, which messed up your game while you were trying to patch it? If so, then this blog post is for you! We have the fix. This article will show you how to get your game working again by installing a keygen program that downloads the DFA.dll file and replaces it with a clean one. This should allow for all games saved on your hard drive (excluding downloaded mods) to work properly! You can also download all versions of the dfa.dll files from our website here if they happen not to be working on your system. This download will work for both the Steam and non-Steam versions of GTA 4. Simply follow these steps: 1) Download this keygen: Download Keygen – GTA IV DFA DLL Fix – Grand Theft Auto 4 Dlls, and click on it. You should see a command prompt window open and close, and the file should be downloaded to your desktop (or wherever you chose to save it). If you don’t see that happen, then most likely the download didn’t go through. Try again later. Also, make sure that your anti-virus is off or set to “do not scan my computer”. 2) Double-click on the .key file and a command prompt window will pop up. This is normal, as it’s going to patch the file for you. 3) A window should appear that says “Press any key to continue”. Go ahead and do that, then press enter on your keyboard as well, to ensure that the process starts properly. 4) Wait for a few seconds as the DLL files gets patched up. If it isn’t working after 5 minutes or so, then reboot your PC and try again (it can take anywhere from 2 min to 15 min to work). Note: If you get the following message when trying to patch the DLL files, “The system cannot find the file specified”, then try restarting your PC. You must restart your PC in order for it to patch up your DLL files correctly. 5) If the files are patched successfully, you should see a new folder on your desktop with a name similar to “gta4_loader.exe” or “gtaco4_loader.exe” that was created by this process. This is where you will move the DFA. dll file that has been patched into. If it doesn’t have a folder with this name, then you have either missed the folder, or the DFA.dll file was not patched correctly. 6) Double-click on the file and follow the onscreen instructions to remove all files necessary for GTA 4 to run properly, including your GTA4.exe file (.exe means executable). 7) Go to “Start > All Programs > Grand Theft Auto IV” to launch GTA 4 again! You should find that your game runs perfectly well now. cfa1e77820
Comments